AirTech SU-27 Flanker Інструкція з експлуатації
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка AirTech SU-27 Flanker. AirTech SU-27 Flanker 2 сторінки.
Друкувати сторінкуUse this instruction Manual to get these Airtech planes assembled and into the air!
Replacement Parts.
If you need to, you can order replacement parts directly from us via telephone or email.
Please call (416) 444-6873 or send an email to [email protected]
Warranty
Interactive Toy Concepts guarantees your Stealth, Burner and Icer to be free from manufacturing defects. This warranty
does not cover any modifications or parts damaged by the owner. In no case will Interactive Toy Concepts' liability exceed
the original cost of the kit. Interactive Toy Concepts reserves the right to change this warranty without notice.
Interactive Toy Concepts assumes no liability over final assembly or for any damage resulting from the use of this product.
If the buyer is not prepared to accept the liability associated with the use of the aircraft, he/she should return it in unused
condition to the place of purchase.
We reserve the right to make improvements to the design of the airplane. Thus, your aircraft may vary slightly from that
depicted in the preceding photographs.
Battery Recycling & Disposal.
It may be illegal to dispose of the NiMH battery in your municipal waste. The battery pack contains a chemical known to
the State of California to cause birth defects or other reproductive problems. Do not try to open the battery pack!
Battery Care Information.
1) Never allow the battery pack to become hot during charging -This will cause permanent irreversible damage.
Warm is OK -HOT IS NOT!
2) Never leave a battery unattended while it is being charged.
3) Never leave a battery unattended in the presence of small children.
4) Charging time required for a full charge increases with the number of charge cycles due to the gradual draining of the
chargers "D" cells.
5) Never recharge a hot battery. Always allow it to cool before charging.
6) If you use an after-market charger, never charge the battery at a rate greater than 500mA.
7) If the flight battery is not completely discharged before recharging, the charging may be less than that of an "empty" battery.
Again, do not allow the battery to get too hot!
8) If a day or more passes without charging the battery, or if you are unsure whether or not it is fully charged, discharge the
battery, then fully recharge it.
9) Rechargeable batteries are to be removed from the toy before being charged (if removable).
10) Rechargeable batteries are only to be charged under adult supervision (if removable).
Troubleshooting.
If you are experiencing any problems with your Airtech aircraft, visit our website under the
Customer Service Tab -Troubleshooting Tips.
There you will find answers to many of your questions, supplied by our Airtech Flight Technicians.
FCC Note: USA only.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference. 2) This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio frequency energy and, if not installed and use in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.
Visit our website: www.interactivetoy.com to see
the complete line of Airtech R/C planes and indoor R/C Blimps!
PLEASE DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
INFORMATION
INFORMATION
®
Contact:
Interactive Toy Concepts Ltd.
1192 Martin Grove Road
Toronto, Ontario, Canada M9W 5M9
INSTRUCTION MANUAL
INSTRUCTION MANUAL
Use this Instruction Manual to get these Airtech planes assembled and into the air!
PRE-FLIGHT
PRE-FLIGHT
Field Charger Preparation.
-Slide the cover off the charger
and install 6 D alkaline
batteries ensuring the polarities
are in the correct alignment.
Make sure to use new
Tip!
alkaline non-
rechargeable batteries for
best plane operation.
Flight Battery Charging.
-Locate the green NiMH flight
battery and plug it into the
charger. Note that the plugs
will only connect in one
orientation. Do not attempt to
force them together.
-Turn the timer dial on the
charger to the end of the
colored band. The timer will
count down and the charger
will shut off when the charge
is complete.
-Do not let the battery get too hot.
Warm is OK- HOT IS NOT!
Always allow the battery
Tip!
to completely discharge
in flight or on the ground before
charging again.
If unsure if a battery is
Tip!
charged or not, always
discharge before recharging.
Kit Includes: R/C plane, Quick Charger, Radio Control System, NiMH Battery, Wind Ribbon, Repair Kit and Instructions.
PLEASE DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
Congratulations on the purchase of your Airtech R/C!
These planes are designed to fly great and be easy to
"learn how to fly". But remember, these are aircraft so
you must spend a bit of time reading through this manual
so you can learn what to do, and what not to do.
Look for these
Tip!
symbols for extra help!
®
Follow these easy steps to get your plane
ready to fly. Be sure to complete each step
correctly to ensure correct plane operation.
Install Transmitter Batteries.
-Remove the rear cover of the
transmitter and install 8 AA
alkaline batteries making sure
that the polarities are correct.
-Switch to ON, and ensure
that the red and green LEDs
light up.
IMPORTANT!
Switch Plane Off!
-Push the power switch on the
underside of the plane to the
off position.
-Always remember to shut your
plane "OFF" whenever it is
being charged, or not in use.
CAUTION:
Never turn "ON" the plane
when the transmitter is "OFF"!
Battery Installation.
-Push the 'catch' located on
the underside of the plane,
rearward and lift up. This will
release the battery cover.
-Plug the battery into the plane
and insert it into the
compartment. Close the cover.
For any questions or problems with this
product please call 1-866-214-2220.
Visit our website: www.interactivetoy.com
or E-mail us at [email protected]