DROPLUX HX-DLV004-RFBK Product Introductie - Pagina 6
Blader online of download pdf Product Introductie voor {categorie_naam} DROPLUX HX-DLV004-RFBK. DROPLUX HX-DLV004-RFBK 7 pagina's. 2.4g wireless-sync-control rgbcw led controller
Pagina afdrukken
Press and hold "RGB-ON" on the remote
control for 5 seconds, the indicator of the
3
remote control will flash quickly, means it
enters the pairing code transmission status.
See the load light flashes 3 times and return to
4
the initial state
（2）Code clearing operation: means that the original code value of the receiver will be cleared
and returned to the factory state. Then it can't be controlled by any remote controller, and can
learn to a new code.
Step
Connecting the load to the receiver and
1
power on it.
Press and hold the remote control
"RGB-Off" for 5 seconds. The indicator of
the remote control flashes quickly, means
2
it enters the clearing code transmission
status. There is no need to select the
corresponding area when clearing code.
See the load light flashes 3 times and
3
return to the initial state
（3） Code learning operation between remote controls: Used to unify system code values or copy
a new remote controls.
Since each remote controller has its own unique code at the time of delivery, when there are multiple
remote controllers in one system, one of them (for example, remote controller A) must be selected as the
system code value, and the code value of the rest remote controllers (for example, remote controller B)
should be copied to the same one.
Step
A remote control：Press and hold "RGB-ON" on the
remote control for 5 seconds, the indicator of the
1
remote control will flash quickly, means it enters the
pairing code transmission status.
B remote control: long press "mode key" for 5
seconds, the remote indicator light changes from
2
100% light to off, means entering the code value
receiving state
see the B remote control indicator light flash 3 times
3
(4) Copying code from receiver to remote control.
A new remote control can also copy code from any one of the receivers in the whole system, after
the successful operation, the new remote control can replace the original remote (if it is lost).
Step
Cut off the power of receiver.
1
Operation
Operation
Operation
corresponding indicator lights up
Will automatically exit code transmission status
after 60 seconds, or pressing any key to exit.
Pairing coding is finished successfully
Instructions
1. The clearing operation should be finished within 1
minutes after the receiver is powered on. If exceeds
the time, can be powered on again.
2. Batch operation can be performed within the
remote control range.
1. Will automatically exit code transmission status
after 60 seconds, or pressing any key to exit.
2. If the original remote controller is lost, the new
remote
controller
can
operations.
Clearing coding is finished successfully
Instructions
Will automatically exit code
transmission status after 60 seconds, or
pressing any key to exit.
Will automatically exit the code value
receiving state after 30 seconds, or exit
after
learning
successfully.
Code copying is finished and exit code
value receiving status.
Instructions
Which one will be controlled by remote.
be
used
for
clearing
the
code
value
6 / 7