Anova TP2502 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Anova TP2502. Anova TP2502 12 pagina's. Battery pruning shears
3. Use and maintenance
3.1 Commissioning
1. Remove the machine from the packaging. Install the lithium battery, press and hold the power switch
for three seconds, and then release it. You should hear the sound of two beeps; this means the battery is
normally charged.
2. Press the trigger continuously and quickly twice to open the blade automatically.
3. Before starting work, press the trigger to operate the blade several times and listen for any unusual
noises or too fast or too slow working speed. If everything is normal, you can start working.
4. Power off: press the trigger and release it after hearing a beep twice. The blade will close
automatically.
3.2 Tips for use
Note:(1) The machine may overheat after continuous use, this is a normal phenomenon. Let the
machine cool down for a while and you can use it again when the temperature drops.
(2) After pruning work is completed, at the end of the season, or when you replace the blade, and need
to remove the blade, add lubricating oil for maintenance of the blade and cutting system.
While you are pruning, start pruning about 8mm from the shoot; the maximum cutting
diameter is 25mm.
Prune away from the shoot to prevent sap loss from the plant.
Do not prune branches too far from the tree as this will reduce the health of the plant.
Leave a small stretch of the branch to avoid stressing the plant.
While working with the scissors, keep your hands away from the cutting blades and wear
suitable gloves and protective gear.
Remove diseased shoots and remove dry branches on the plant.
When pruning on a tree, prune each branch separately and do not cut multiple branches
at once.
3.3 Battery charging
The battery of a new machine is not fully charged. Before
charging, insert the battery into the charger and insert the plug of the
charger into the wall outlet. The "+" of the battery must be inserted into
the "+" of the charger, as shown in the picture on the right. The indicator
light on the charger will show green once it is fully charged. Always use
the battery after full charges.
3.4 Special attention
1. Before charging, please turn off the switch; During charging, it is normal to have a slightly warm
charger and batteries.
2. If the batteries are not used for a long time, they should be recharged every 3 months to increase the
service life;
3. New batteries or batteries not used for a long time will reach full capacity after 5 times of charge-
discharge cycles;
4. Please do not charge the batteries repeatedly after several minutes of operation, this may reduce the