DSC Envoy NT9010 Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DSC Envoy NT9010. DSC Envoy NT9010 20 pagina's. Demo stand
Ook voor DSC Envoy NT9010: Installatie-instructies (4 pagina's)

Pagina afdrukken

Turning Off

1. If you are outside, enter through the entry/exit door. The keypad beeps to

Your System

remind you to turn off the system.

NOTE: Entering by any other door will immediately cause an alarm.

If you are inside, go to the keypad (the keypad will not beep).

2. Enter your [access code]. If you have entered from outside, you must enter the

correct access code before the keypad stops beeping. If you do not enter a valid

access code during this time, the system will sound an alarm.

NOTE: If you have entered the wrong code the keypad will sound one long

beep - try again to enter the correct code.

As soon as you enter the correct code, the red (Armed) light turns OFF and the

keypad stops beeping.

3. If an alarm occurred while the system was on, the NT9010 will announce: "Sys-

tem is off. There are (number) alarms in memory: {Zone XX}." See Checking

Alarms in Memory on page 16.

CAUTION: If you return and find that an alarm has occurred while you

were away, it is possible that an intruder may still be on the premises. Go to

a nearby safe location, and call your central station or the local authorities

to investigate. The alarm memory is cleared each time the system is turned

on, so any alarms showing have occurred only during the last time the sys-

tem was on.

Other Ways to

There are two basic methods for turning on your security system.

Turn Your

• Away: Use this method when everyone will be away from the premises. See

System On

page 11.

• Stay: Use this method when one or more people will stay on the premises. See

page 12.

You can also use any of the following methods to turn on your system (see pages

10 to 11):

• Quick Arming: Turn on your system without having to enter an access code.

Your installer must turn on this feature before it will work.

• "No Entry" Arming: Turn on your system with no entry time - use this method

when no one else will be entering the premises.

• Automatic Arming: The system will turn itself on at pre-set times. Your

installer must turn on this feature before it will work.

NOTE: When turning on your system from a remote telephone, the system

will automatically be in Stay mode. (See Turning On Your System While

You Are At Home (Stay Mode) on page 12.)

Section 7: Fire Safety

Read this section carefully. It contains important information about fire safety.

Household

Most fires occur in the home. To minimize this danger, we recommend that a

Fire Safety

household fire safety audit be done and a fire escape plan be created.

Audit

1. Are all electrical appliances and outlets in a safe condition? Check for frayed

cords, overloaded lighting circuits, etc. If you are uncertain about the condition

of your electrical appliances or household service, have a professional evaluate

these units.

2. Are all flammable liquids stored safely in closed containers in a well-ventilated,

cool area? Cleaning with flammable liquids should be avoided.

3. Are fire hazardous materials (e.g., matches) well out of reach of children?

4. Are furnaces and wood burning appliances properly installed, clean and in

good working order? Have a professional evaluate these appliances.

Fire Escape

There is often very little time between the detection of a fire and the time it

Planning

becomes deadly. Therefore it is very important to develop and rehearse a family

escape plan.

1. Every family member should participate in developing the escape plan.

2. Study the possible escape routes from each location within the house. Since

many fires occur at night, special attention should be given to the escape

routes from sleeping quarters.

3. Escape from a bedroom must be possible without opening the interior door.

Consider the following when making your escape plans:

• Make sure that all exterior doors and windows are easily opened. Ensure that

they are not painted shut, and that their locking mechanisms operate smoothly.

• If opening or using the exit is too difficult for children, the elderly, or the handi-

capped, plans for rescue should be developed. This includes making sure that

those who are to perform the rescue can promptly hear the fire warning signal.

• If the exit is above the ground level, an approved fire ladder or rope should be

provided as well as training in its use.

• Exits on the ground level should be kept clear. Be sure to remove snow from

exterior patio doors in winter. Outdoor furniture or equipment should not block

exits.

• Each person should know of a predetermined assembly point where everyone

can be accounted for (e.g., across the street or at a neighbor's house). Once

everyone is out of the building, call the Fire Department.