DSC Power Series PC1616 PC1832 PC1864 System Manual
that it was improperly armed in two ways: the keypad will emit one continuous beep and the bell or siren
will sound.
Your installer will tell you if this feature has been enabled on your system. If this occurs:
1. Re-enter the premises.
2. Enter your [access code] to disarm the system. You must do this before the entry delay timer
expires.
3. Follow the Away Arming procedure again, making sure to close the entry/exit door properly.
Arming Error
An error tone will sound if the system is unable to arm. This will happen if the system is not ready to arm
(i.e., sensors are open), or if an incorrect user code has been entered. If this happens, ensure all sensors
are secure, press [*] and try again.
Disarming (Turning Off /Unsetting)
Enter your access code to disarm anytime the system is armed (i.e., the Armed (lock) indicator is on). The
keypad will beep if you walk through the entry door. Enter your code within the allotted time to avoid an
alarm condition (please check with your installer to have this time programmed).
Disarming Error
If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this happens,
press [#] and try again.
Stay Arming (Partially Turning On / Part Setting)
Stay arming will bypass the interior protection (i.e., motion sensors) and arm the perimeter of the system
(i.e., doors and windows). Close all sensors (i.e., stop motion and close doors). The Ready (checkmark)
indicator should be on. Ask your alarm company if this function is available on your system.
Press and hold the Stay key for 2 seconds and/or enter your Access Code and do not leave the premises
(if your installer has programmed this button). During the setting state (exit delay active), the Armed (lock)
and Ready (checkmark) indicators will turn on, and the keypad will sound one beep every three seconds.
When the exit delay is completed, the alarm system is armed/set and this is indicated on the keypad as
follows: the Ready (checkmark) indicator will turn off, the Armed (lock) indicator will remain on and the
keypad will stop sounding. The Armed (lock) indicator and Bypass or System indicator will turn on. The
system will automatically bypass certain interior sensors (i.e., motion sensors).
Note: For SIA FAR listed panels, the Stay Arming Exit Delay will be twice as long as the Away Arming Exit
https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]
Pagina afdrukken