ATT Holding Kade KZ-700-U/H Installatiehandleiding - Pagina 10

Blader online of download pdf Installatiehandleiding voor {categorie_naam} ATT Holding Kade KZ-700-U/H. ATT Holding Kade KZ-700-U/H 12 pagina's. Integrated access controller

Pagina afdrukken

Integrated Access Controller – Installation manual

Relay Setting (Pulse mode, Toggle mode)

Pulse mode (Factory default)

Pulse mode ( Door relay time setting )

Toggle mode

Door Detecting, Alarm, Sound and Light Settings

Door Open Detection

Door Open Too Long (DOTL) warning. When used with an optional magnetic contact or built-in magnetic con-

tact of the lock, if the door is opened normally, but not closed after 1 minute, the inside buzzer will beep auto-

matically to remind people to close the door and continue for 1 minute before switching off automatically.

Door Forced Open warning. When used with an optional magnetic contact or built-in magnetic contact of the

lock, if the door is opened by force, or if the door is opened after 20 seconds of the electro-mechanical lock

not closed properly, the inside buzzer and alarm output will both operate. The Alarm Output time is adjustable

between 0~3 minutes with the default being 1 minute.

Alarm output time

To set the alarm output time (0~3 minutes)

Door open detection setting

To disable door open detection

(Factory default)

To enable door open detection

Keypad Lockout & Alarm Output options. If there are 10 invalid cards or 10 incorrect PIN numbers in a 10

minute period either the keypad will lockout for 10 minutes or the alarm will operate for 0~3 minutes, depend-

ing on the option selected below.

Normal status: No keypad lockout or alarm

(factory default)

Keypad Lockout

Alarm Output

Light and Sound Setting

To set keypad backlight

To set LED

To set Acoustic Signal

The acoustic signal can be set on or off.

When on, the device will give the voice

when press the keys; when off, the device

will be in silent.

4 1 1~99 # Zone 1

4 2 1~99 # Zone 2

The door relay time is between 1~99 seconds, the factory de-

4 1 0 # Zone 1

4 2 0 # Zone 2

5 0~3 # Factory default is 1 minute

6 0 #

6 1 #

7 0 # (Factory default)

7 1 #

7 2 #

81 0 # To disable keypad backlight

81 1 # To enable keypad backlight (Factory default)

82 0 # To disable the RED Led

82 1 # To enable the RED Led (Factory default)

83 0 # To disable the keypad tone

83 1 # To enable the keypad tone (Factory default)