Attwood Tsunami 4606 Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} Attwood Tsunami 4606. Attwood Tsunami 4606 2 pagina's. Attwood tsunami bilge pump installation instructions

Pagina afdrukken

Figure 3

Fuse Holder

2-Terminal

On/Off Switch

Brown Wire

1. Connect positive lead (brown) to switch. For automatic operation,

use Attwood Automatic Float Switch (#4201 or 4202). Connect

negative lead (black) to ground.

2. Install fuse holder within 72" (183 cm) of the positive (+) battery

terminal. Use standard automotive (SAE J554) glass tube type

electrical fuse.

3. To test system, feed water into the pump. If flow appears low, be

sure wires have been connected properly: Brown-to-positive (switch),

and black-to-negative. Reversed wiring reduces performance and

can cause pump failure.

72" (183cm) Max. Length

From (+) Terminal to Fuse

Black Wire

(neg)

(pos)

12 or 24 Volt DC

(Power Source)

MAINTENANCE AND TROUBLESHOOTING

Disconnect power to the pump. Regularly inspect and clean to be

sure that debris is not blocking the strainer or impeller.

If pump runs but does not pump water:

1. Check for airlock. Be sure that outlet hose runs upward to the

thru-hull connector, with no dips. (Figure 1)

2. Remove pump housing from base. Remove debris from chamber

and impeller. Be sure impeller is firmly attached to shaft and is not

cracked or broken. (Figure 2)

If pump does not run:

1. Check fuse. Be sure electrical connections and fuse are waterproof

and haven't loosened. (Figure 3)

To replace motor cartridge:

1. Hold pump housing, depress motor cartridge tab and twist cartridge

counter-clockwise to remove (Figure 2).

2. Check motor cartridge fit: See specification chart for replacement

motor cartridge number. Motor must match housing color:

500 Series = RED, 800 = BLUE, 1200 = GRAY.

3. To reinstall cartridge: Coat O-ring with vegetable oil (petroleum-based

oils will cause deterioration).

4. Insert cartridge into housing. Twist clockwise until you hear tab

snap up into slot. (Figure 2)

ATTWOOD BILGE PUMPS LIMITED WARRANTY

This Attwood Bilge Pump carries a three (3) year warranty.

See product catalog or www.attwoodmarine.com for details.

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com