Elite Acoustics Engineering A4-8 Snelstarthandleiding - Pagina 11
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Elite Acoustics Engineering A4-8. Elite Acoustics Engineering A4-8 13 pagina's. Live-performance studio monitor with 4 channels, mixer, effects, and bluetooth
Pagina afdrukken
•
Distorted Sound
•
1) Check input level to make sure input Signal Light is in GREEN and not CLIP-
PING RED. Reduce Input by turn down GAIN knob (12, 22, 30), input Gain can
also be reduced by Pressing "PAD" (16, 26), some MIC or PRE-AMPs have very
high output level, using the PAD switch for those devices and will help you re-
duce the chance of distortion. Make sure all EQ knobs are set to Middle. (FLAT)
•
2) Check Monitor Signal Light is also GREEN and not Clipping. Reduce Speaker
Level by turning Monitor Knob (3), make sure EQ is set to middle (FLAT)
•
•
No Sound
•
1) Check LED signal lights. Green means there is Signal on the input.
•
2) Make sure MIX knob is at 12 o'clock position.
•
3) Make sure Channel is un-muted.
•
4) Make sure +48V is on when using a Condenser Mic. Make sure to MUTE
when turning on +48V to prevent loud POP sound.
•
•
Battery not Holding Charging
•
1) Power unit off and charge the unit for 24 hours with Battery switch in Connect-
ed position. If problem still persist, contact [email protected] for battery
replacement instructions.
•
•
DIGITAL EFX
16 DIGITAL EFX PROGRAMS
•
•
There are 16 total Digital EFX programs
•
R1 to R10 - REVERB
•
E1 and E2 - ECHO
•
ER1 and ER2 - Echo and Reverb
•
CHO - Chorus
•
FLange - Flanger
•
•
Program select Encoder (10) is for pro-
gram change.
•
Parameter knob (9) to change rate or
delay time for the program that is set.
•
Mix knob (8) is to fine turn the amount of
EFX you want in output mix.
•
EFX can be bypassed by Pressing the
bypass switch (9)
•
EFX send levels for each channel is set
by on the rear panel ( 14, 24, and 31)
that correspond to each channel.
•
TIPS