Concoa 5295135-01-120 Handleiding voor installatie en gebruik - Pagina 6

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Concoa 5295135-01-120. Concoa 5295135-01-120 13 pagina's. Protocol station remote alarm

Pagina afdrukken

OPTION 1 (continued)

Using the pin assignments shown in Table 1 and the connector view in Figure 3, solder the wires to the

appropriate pins. After soldering is complete attache the cable cover, cable retainer, and locking nut to

each of the circular connector plugs.

Plug the one side of the cable into the Remote Alarm and secure it by turning the locking nut until it

locks. Plug the other circular connector into the Protocol Station securing it by turning the locking

nut until it locks.

OPTION 2: For Protocol Stations that have a 4 pin circular connector.

It will be necessary to obtain a 4 conductor cable. The length of the cable is determined by the application

but should be limited to no longer than 1500 feet. It is recommended that 22 AWG stranded wire be

used. (Alpha #5004C is an acceptable type.)

Cut the 4 conductor cable to length. Remove the outer jacket of the cable to expose approximately 11⁄4

inches of the internal conductors. Strip away 1⁄4 inch of the insulation on each of the 4 conductors. Tin

the leads of the conductors. Slide the protective cover, cable retainer, and locking nut for the circular

connector over one end of the cable as shown in Figure 4.

Figure 5 - View A-A

SYSTEM

RIGHT BANK

Cable Retainer Tabs

Cable Cover

Cable Retainer

notch

Table 2

Protocol Station

Pin #

---

Connector pins (Figures 3 and 4)

viewed from this side

Locking Nut

Figure 4

Figure 6 - View A-A

Remote Alarm

Connector Pin #

---

Plug

notch

Function

RBSW status

alarm

+12

Gnd