AnyTone AT-5289 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AnyTone AT-5289. AnyTone AT-5289 13 pagina's.

c) It is necessary to connect your radio to a permanent (+) and (-). We

advise you to connect the power cable directly to the battery (as the

connection of the cable to the wiring of the car-radio or other parts of

the electrical circuit may, in some cases, increase the possibilities of

interference).

d) Connect the red wire (+) to the positive terminal of the battery and the

black (-) wire to the negative terminal of the battery.

e) Connect the power cable to your CB radio.

WARNING: Never replace the original fuse (5A) by one of different value.

BASIC OPERATIONS

a) Connect the microphone

b) Check the antenna connections

c) Turn the set on by turning the volume knob clockwise

d) Turn the squelch knob to minimum(Full-anti clockwise)

e) Adjust the volume to a comfortable level

f) Go to channel 20 EC by using the channel knob.

WARNING: This must be carried out when you use your radio for the first time

(and whenever you re-position your antenna). The adjustment must be carried

out in an obstacle-free area

＊Adjustment should be operated with external SWR meter.

a) To connect the SWR meter

Connect the SWR meter between the radio and the antenna as close

as possible to the radio (use a maximum of 40cm cable)

b) To adjust the SWR meter -Set the to channel 20@EC band in FM

-put the switch on the SWR meter to position CAL or FWD -Press the

PTT switch on the microphone to transmit.

-Bring the index needle to ▼ by using the calibration key

-Change the switch to position SWR (reading of the SWR level) The

reading on the meter should be as near as possible to 1. If this is

not the case, re-adjust your antenna to obtain a reading as close as

possible to 1.( An SWR reading between 1 and 1.8 is acceptable).

-It will be necessary to re-calibrate the SWR meter after each

adjustment of the antenna.

Your radio is now ready for use