Duerkopp Adler 506 Handleiding voor installatie-instructies - Pagina 3
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Duerkopp Adler 506. Duerkopp Adler 506 8 pagina's.
Ook voor Duerkopp Adler 506: Gebruiksaanwijzing (17 pagina's)
Pagina afdrukken
2.3 Attaching the Yarn Stand
2.4 Checking the V-belt Tension
4
–
Insert the yarn stand into the appropriate hole in the table and
attach with the nuts and washers.
After transport the V-belt tension set at the factory is to be checked.
The notched V-belt must be under sufficient tension for the unit to run
softly into the end position.
Tension the V-belt so that it can be pushed in at the center approx.
10 mm by finger pressure.
Correcting the V-belt tension:
–
Loosen nut 1.
–
Swing the sewing drive 2 until the desired V-belt tension is
achieved.
–
Tighten nut 1.
1
2