Duevi SINT-13 Installatie- en gebruikshandleiding - Pagina 5
Blader online of download pdf Installatie- en gebruikshandleiding voor {categorie_naam} Duevi SINT-13. Duevi SINT-13 8 pagina's. Wireless voice synthesis receiver with activation
Pagina afdrukken
RESET
It's recommended to proceed with this operation at the first use of the device, in order to erase radio codes
during the factory tests.
1.
Power on the device holding down the P2 button until all four LEDs blink
2.
Release the P2 button
3.
Power off and wait some seconds
4.
Power on again SINT-13: reset is done
RADIO CODES LEARNING
Enter in "radio code learning" mode
1.
Close the jumper JP1 on pins A and B.
As soon as the pins are shorted:
LD4 (RED) lights solid on
LD2 blinks one time then stay solid on: this means SINT-13 is ready to learn the radio code in
position 1 (REMOTE CONTROLS).
2.
Now it is possible to learn the radio code:
Press the P2 button, the LD3 (BLUE) LED lights on.
From this moment SINT-13 is waiting for a radio code to learn. When a valid radio code is sent,
LD2 and LD3 blink confirming the correct learning, then LD3 switch off.
3.
To move to next memory position (next radio code):
press briefly P1. As confirm LD2 blinks as many times as the number of memory position then
stay solid on.
(Example: 3 blinks = radio code in position n° 3 [DETECTOR]).
Repeat the learning steps.
Proceed for all the codes in the same way.
To learn the remote controls and the control panel (or TSR) just store any radio code from them (eg.:
only the disarming). The rest of the association code transmitted/voice message will be automatic.
Example: to learn a TXS/M remote press the SMALL button (disarming): the BIG button of the TXS/M
will be automatically recognized and combined to its proper voice message.
Example: to learn a TSR transmit "TOTAL arming". "Partial 1 arming", "Disarming", etc. will be
automatically added.
WARNING
THIS OPERATION ERASE ALL RADIO CODES STORED
5