Danfoss VLT AutomationDrive FC 302 Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss VLT AutomationDrive FC 302. Danfoss VLT AutomationDrive FC 302 16 pagina's. Igbt module replacement for d1h–d8h drives
Ook voor Danfoss VLT AutomationDrive FC 302: Bedieningshandleiding (16 pagina's), Installatiehandleiding (20 pagina's), Installatie-instructies (4 pagina's), Handleiding voor installatie-instructies (6 pagina's), Handleiding voor installatie-instructies (12 pagina's), Installatiehandleiding (18 pagina's), Handleiding voor installatie-instructies (8 pagina's), Handleiding voor installatie-instructies (10 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (16 pagina's), Gebruiksaanwijzing (16 pagina's), Handleiding voor installatie-instructies (6 pagina's), Installatiehandleiding (8 pagina's), Handleiding voor installatie-instructies (6 pagina's), Installatiehandleiding (6 pagina's)

Pagina afdrukken
Danfoss VLT AutomationDrive FC 302 Installatiehandleiding
Installation Guide | VLT® Programmable I/O MCB 115
Temperature sensor (1000 Ω at 0 °C
(32 °F)
Accuracy
Temperature range
Resolution [bits]
Sampling [Hz]
Maximum load
Impedance
Maximum cable length for temperature sensors is 50 m (164 ft) non-shielded/non-twisted wires.
-
Keep cable impedance low as every 3.85 Ω in cables gives a misreading of 1 Kelvin.
-

3.4.1.2 Programmable Outputs

The 3 programmable outputs can work as:
•
analog voltage outputs.
•
analog current outputs.
•
digital outputs.
Table 3: Programmable Outputs
Used as digital output
Number of outputs
3
Terminal
X49/7–12
Voltage/current range
•
•
•
Accuracy
–
Resolution [bits]
–
Maximum load
–
Load impedance
–
12 | Danfoss A/S © 2020.01
Used as temperature sensor
input
Ni1000 (according to DIN 43760)
Pt1000 (according to IEC 60751)
-50 °C ±1 Kelvin
+150 °C ±2 Kelvins
-50 °C (-58 °F) to +150 °C
(+302 °F)
10
3
–
–
Maximum voltage at low output: 4 V
Minimum voltage at high output: 20 V
Maximum output current: 24 mA
Used as analog voltage
input
–
–
Better than 1% of full scale
–
10
Minimum 2
±28 V continuously
10 kΩ
N O T I C E
Used as analog voltage output
3
X49/7–12
0–10 V DC
Better than ±1%
10
±28 V continuously
≥10 kΩ
Installation
Used as current input
–
–
Better than 1% of full
scale
–
10
Minimum 2
±29 mA continuously
200 Ω
Used as current output
3
X49/7–12
0–20 mA
Better than ±1%
10
±29 mA continuously
≤200 Ω
AN295938195323en-000101 / 130R0655