Addonics Technologies RT3DAHEU3 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Addonics Technologies RT3DAHEU3. Addonics Technologies RT3DAHEU3 4 pagina's.

Pagina afdrukken

Default factory DIP Switch setting:

SW1 – RAID Setting DIP Switch

BZS – Error buzzer function

EZ –

Automatic rebuilding to spare drive (one of the drives on the raid is set as a

spare). If EZ is ENABLED anda drive failure occurs, the spare will

automatically act as a drive replacement and rebuilding will automatically

start.

M2 –

RAID mode 2

M1 –

RAID mode 1

SW1

M0 –

RAID mode 0

Error buzzer function is ENABLED (BZS) when dip switch is in OFF position

Auto-rebuilding to spare drive is DISABLED (EZ)

Individual drive mode is ENABLED (M0~M2)

Note: When the default factory RAID setting is used, independent drive configuration

and optical drive are supported only when connecting to controllers with Silicon

Image Sil3124, Sil3132 chip set or controllers that are Port Multiplier (PM)

compatible. Simultaneous DVD writing was tested using the Nero Burning Rom.

LED Pin Header

P5 P0 P1 P2 P3 P4

Error LED

J1 – Drive Activity LED

P5 –

Activity LED for eSATA host port lights up when it is connected to a

SATA controller card.

P0, P1, P2, P3 & P4 - Activity LEDs for port 0, 1, 2, 3, 4 & 5 light up when a drive is

connected and blinks when there's drive activity.

J3 – Error LED

P5 –

error LED for eSATA host port

P0, P1, P2, P3 & P4 - error LED for port 0, 1, 2, 3, 4 & 5

www.addonics.com

BZS EZ M2 M1 M0

P5 P0 P1 P2 P3 P4

Activity LED

Technical Support (M-F 8:30am - 6:00pm PST)

Setting or Modifying the RAID Mode Using the JMicron

HW RAID Manager Utility Program:

For Windows users, install the JMicron HW RAID Manager located on the

SATA Controller CD. In the CD, go to Configuration Utilities > JMB393. This

manager can be use to create and monitor the status of the RAID volume.

It is recommended to use the default factory RAID DIP switch setting when

using the JMicron HW RAID Manager.

Modify the RAID mode on the 5-port HPM-XA using DIP switch

Recommended to be used on operating system without JMicron HW RAID

Manager support like Linux, Mac & Solaris. Windows users can also use the

procedure below.

Note: Steps A to D need to be performed each time the raid mode is modified.

Set the DIP switch to factory default setting.

SW1

BZS EZ M2 M1 M0

Press the RAID setting button with a ball point pen.

While pressing the RAID setting button turn on the system power

where the HPM is connected. The buzzer will sound while holding the

RAID setting button. Release it after at least 5 seconds for hardware

initialization. A single beep will be heard to indicate initialization is

completed. The above steps act as a reset.

Power off the system power.

Phone: 408-453-6212

Email: www.addonics.com/support/query/