Abus Vitess Rim Servicehandleiding - Pagina 14

Blader online of download pdf Servicehandleiding voor {categorie_naam} Abus Vitess Rim. Abus Vitess Rim 20 pagina's.

Abus Vitess Rim Servicehandleiding

ASSEMBLY INSTRUCTIONS - KNK/KIL

Delivery of the pre-loaded housing
Our pre-loaded housing includes all parts that are necessary to
assemble a functional cylinder. Inside the cylinder there is a
black plastic plug which has to be exchanged by a pinned core.
The housing is filled corresponding to the factory standard with
steel springs and housing pin
In addition, the following parts are included: tailpiece package,
screw cap, tappet and spring
Step 1
Insert the cut key into the cylinder core
Place the profile check pin in the core
Step 4
Position the pinned core with the inserted
cut key and rotate the core to the 2 o'clock
position
Step 7
Insert the spring and the tappet into
the drill hole on the backside of the
core (flat side of the tappet goes
into the core)
14
Step 2
Insert the hardened InTop pin into the 1st
chamber
Attention: Pull the key a little and insert
it again
Step 5
Push the core inside until the plastic plug
has been pushed through completely.
Rotate the core forward clockwise until the
key is at the 12 o'clock position
Step 8
Push the tappet down and insert
the tailpiece and screw together
with screw cap on the backside
of the core
Step 3
Insert the bottom pins made of hardened
steel into the 3rd chamber
Insert the bottom pins made of nickel silver
into the 2nd and 4th to 6th chamber
Only for master keyed systems: Insert master
wafers
Check with cut key – no pin should be
positioned too low or above the shear line
of the core – control with assembly tool
possible
Step 6
Remove the key by holding the core with
your thumb
The core isn't fixed yet and could be pulled
out with key inside