Dascom DP-520 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dascom DP-520. Dascom DP-520 19 pagina's. Wired printer
Ook voor Dascom DP-520: Gebruikershandleiding (12 pagina's), Snelle installatie-instructies (2 pagina's), Snelle installatie-instructies (2 pagina's)

The printer is normally supplied with a standard 1.8Ah NiMH battery pack. The primary power for the printer

comes from the battery pack.

The printer can operate with or without a charger connected. If required, the charger can be operated continuously

to keep the battery fully charged, although a high printing duty cycle may reduce the charge in the battery.

Operation from the charger alone is not possible: a battery pack must always be installed.

Note: For safety the battery pack is shipped in the battery compartment, but discharged and disconnected.

Before use, the battery must be connected (see below) and then fully charged.

The procedure for connecting the battery pack is as follows:

1. Remove the screw from the battery compartment door,

2. Push down, and slide back the battery compartment door,

3. Insert the battery pack connector taking care to insert it correctly,

4. Make sure the wires are correctly routed and not trapped.

Plug the battery charger into a suitable power source and insert the plug into the power connector at the rear of the

printer. The Status Indicator will flash orange to show that the printer is charging.

There is also the option of charging the printer via the connector in the D9 data connector on the optional serial

cable.

BATTERY PACKS