Data Signs PTL Remote Bedienings- en onderhoudshandleiding - Pagina 6

Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} Data Signs PTL Remote. Data Signs PTL Remote 19 pagina's. Portable traffic lights

Pagina afdrukken

Shuttle Control – Single-Lane Usage

Shuttle Control is a form of traffic control used where a portion of the roadway is closed

so that only a single lane can be used alternatively by traffic from opposite directions.

Only one Traffic Light unit can show the Green signal phase at any time; either the Master

or the Slave. The diagram below illustrates the traffic control scenario where Shuttle

control would typically be used.

Note: This diagram should not be used as a guideline for setting up a roadwork site, it is

provided as an example only.

Unit ID: 0

Unit ID: 1

ROADWORKS

REMOTE

CONTROL

SITE

= Rear Flashing Beacon

SHUTTLE CONTROL

These illustrations are intended to outline the different modes which can be used with Data Signs Portable Trafﬁc Lights and should not be used as examples or guidelines on how to setup a

Each PTL unit will go to the Green signal phase in turn. See timing diagram later in this

manual.

Shuttle Control is active while the left key-switch on the Master Controller is in the

SHUTTLE position. Operating mode using Shuttle Control is described in more detail on

the following page.

D A T A S I G N S A U S T R A L I A P T Y L T D