Data Signs PTL Remote Посібник з експлуатації та технічного обслуговування - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Засоби безпеки Data Signs PTL Remote. Data Signs PTL Remote 19 сторінок. Portable traffic lights

Shuttle Control – Single-Lane Usage
Shuttle Control is a form of traffic control used where a portion of the roadway is closed
so that only a single lane can be used alternatively by traffic from opposite directions.
Only one Traffic Light unit can show the Green signal phase at any time; either the Master
or the Slave. The diagram below illustrates the traffic control scenario where Shuttle
control would typically be used.
Note: This diagram should not be used as a guideline for setting up a roadwork site, it is
provided as an example only.
Unit ID: 0
Unit ID: 1
ROADWORKS
REMOTE
CONTROL
SITE
= Rear Flashing Beacon
SHUTTLE CONTROL
These illustrations are intended to outline the different modes which can be used with Data Signs Portable Traffic Lights and should not be used as examples or guidelines on how to setup a
roadwork site − Separate documentation is available for these purposes. Copyright © 2020 Data Signs Pty Ltd. All rights reserved.
Each PTL unit will go to the Green signal phase in turn. See timing diagram later in this
manual.
Shuttle Control is active while the left key-switch on the Master Controller is in the
SHUTTLE position. Operating mode using Shuttle Control is described in more detail on
the following page.
6
D A T A S I G N S A U S T R A L I A P T Y L T D