Elsner P03/3 Technische specificaties en installatie-instructies - Pagina 9

Blader online of download pdf Technische specificaties en installatie-instructies voor {categorie_naam} Elsner P03/3. Elsner P03/3 11 pagina's.

Set jumper:

Please reboot the system after the setting of the jumper!

Control model

WS1000 Touch

All other models up to production year 2001

All other models from production year 2002 on

2.3.5. Mounting the sensor

Close the housing by putting the cover back over the bottom part. The cover must snap

in on the left and right with a definite "click".

To remove it, the sensor can be simply pulled upwards out of the mount, against the

resistance of the fastening.

2.4. Notes on mounting and commissioning

Do not open

weather station if water (rain) might ingress: even some drops might

damage the electronic system.

Observe the correct connections. Incorrect connections may destroy the weather sta-

tion or connected electronic devices.

Please take care not to damage the temperature sensor (small blank at the bottom part

of the housing.) when mounting the weather station. Please also take care not to break

P03/3 Weather Station • Status: 09.06.2016 • Technical changes reserved. Errors reserved.

Fig. 13

Make sure the cover and bottom part are

properly snapped together! This picture is

looking at the closed sensor from under-

neath.

Fastening

Fig. 14

Push the housing from above into the fas-

tened mount. The bumps on the mount must

snap into the rails in the housing.

Installation and commissioning

Jumper position

no jumper

jumper at position (a)

jumper at position (b)