Cayken KCY-520WEQ Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Cayken KCY-520WEQ. Cayken KCY-520WEQ 16 pagina's.

APPLICABLE PROJECTS

The machine is applicable for cutting or slotting on armoured concrete, concrete brick wall,

stone material such as marble and wall.

Check the following points before plugging in:

1.Use rated power supply

If the machine does not use rated power supply,it can not work.Please notice that only

the machine uses the right rated power supply and keeps the current in the control

cabinet at 6A,no more than 10A,the machine can work to its optimal efficiency and

without damage.

2.Make sure that the switch is in position"Off"

The switch on the control cabinet of the machine can be easily switched on.Make sure all

switches of the machine are off before plugging in to avoid the accident.

3.Make sure the blade is correctly fixed

Lock the blade screw in the clockwise direction.Fasten it with the open end wrench and

rotate the blade screw to see if it rubs with the blade guard.If it does,adjust the blade

and the blade guard before use.

A.Installation of the machine

Install the track way first,and then fix the machine on the track way.In order to cut the

wall surface flatly,the right method to install the track way is:The motor is on top and the

saw web in the downside.Keep the rotating direction of the saw web against that of the

running direction of the motor.In this case,it can not reduce the cutting time,but also

improve the cutting capacity.

1.Drill one anchoring spurs for the setscrew of 16.3-16.5mm in diameter and 55mm in

depth with the percussion drill at the position of133±2mm from the facet.It can hold a

machine with a M12 setscrew.The guide rail can be fixed in any place around the

anchoring spurs.

2.Use an air pressure gun to clean away the pieces in the anchoring spurs.

3.Drive in a machine with a M12 setscrew,insert a loosening bar into the screw hole,and

knock the fixed setscrew with a hammer.Make sure the setscrew is fixed tightly in the

holes,or else it may move or drop down in operation.Use the outfitted setscrew and screw

and so on to fasten the guide rail outfit.The number of the setscrew depends on the

softness of the cutting plane.The track way must be fixed tightly.