Dustie DAC500 Plus Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} Dustie DAC500 Plus. Dustie DAC500 Plus 16 pagina's.

Control panel / cleaning maintenance

High efficiency filter (HEPA) indicator light / reset button

When the air cleaner is used for 6 months, the HEPA replacement indicator light (red) will keep

blinking to remind you to replace the HEPA. After the HEPA is replaced, press and hold the

indicator light for about 5 seconds. The indicator light no longer blinks and then it is extinguished.

The timer is reset. Timer has been reset. There will be a prompt upon the next setting time. Tips:

It's suggested the HEPA should be replaced every 6 to 12 months according to the different use

circumstances. (If the air cleaner is often used, it's suggested the HEPA should be cleaned once a

month in order to achieve the desired filtration effect.)

Light control:

In the power on mode, press (

indicator light.Please note that the setting will be stored in the permanent memory.To be specific,

once the air cleaner is re-switched on after powering off, the brightness of the indicator light remains

the same as the last one.

Notes: There are four degrees of brightness: normal brightness - medium brightness (initial value) -

half brightness - (air quality indicator light) being extinguished + (blue indicator light) maintaining

half brightness.

[Product cleaning and maintenance]

Remove the filter covers,

clean them gently with the

little-brush sucker of a

vacuum cleaner or wet cloth

and assemble them again

when they are completely dry.

Do not immerse the product into

water or wipe it with chemical

Caution

cleansers. Keep water from

entering the product.

) reset button to set the air quality and the brightness of the blue

Wipe outer surfaces of

covers of the main body

gently with wet cloth. Keep

water from entering the air

inlet and outlet to avoid

impact on the motor or the

switch position.