Dusty Strings P20 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Dusty Strings P20. Dusty Strings P20 6 pagina's. Pickup for lever harps

Carefully remove the template from inside the harp.

You should now have 3 or 4 (depending on model) clearly visible pencil dots on the soundboard and corresponding

'X' marks for the harness clips on the lining.

Step 5: Attach Harness Clips

Note: Please read this section completely before attaching clips.

Place a paperclip or thin coin on the soundboard under the

lowest 'X' mark on the soundboard lining to act as a spacer.

This is to prevent the harness clip from touching the sound-

board and causing unwanted vibration.

Remove the paper backing from the self-adhesive patch on

one of the harness clips.

Orient the angled corners away from the soundboard and use

the spacer to position the bottom edge of the clip up off the

soundboard (see figure 6).

Firmly press the clip into place over the 'X' on the soundboard

lining, keeping it as square to the soundboard as possible. The clip may be wider than the lining, and this is okay.

Remove the spacer.

Repeat for the remaining clips.

Step 6: Attach Pickup Harness

Slide the pickup harness up through the bottom sound hole, being careful to avoid dragging or bumping the jack

against the harp.

Orient the harness so the pickup element lead wires point toward the string rib, away from the side of the harp

figure 7 on next page).

Slide the rubber grommets on the harness so that they align with the clips while allowing the pickup elements to line

up with the marks on the soundboard.

Press the rubber grommets into the clips. The groove in each grommet should snap into place in the arms of the clip.

It is not necessary to twist the clips' "ears" together.

If your particular installation leaves you with an extra grommet (this will be the case with the FH36S), you can

either leave it alone, or you can very carefully cut it off with a sharp blade, diagonal cutter, or scissors.

Soundboard

Figure 6 – Spacers

(See next page)

Soundboard

lining

Spacers

(see