DataStor Compaq Proliant Ultra2 SCSI III Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} DataStor Compaq Proliant Ultra2 SCSI III. DataStor Compaq Proliant Ultra2 SCSI III 2 pagina's. 80pin hot plug tray

Pagina afdrukken

Connect Tray Cables to Drive

NOTE: Please reference the documentation that came with your

hard drive for identification of proper connections on your drive.

1. Connect the HD 68pin I/O cable from the tray to the back of

the drive.

2. Connect the four-pin power connector to the back of the drive.

3. Connect the SCSI/Activity Jumper connector to the rear of

the drive. Orient the connector so that Pin 1 (The Red Wire

on the connector) orients with Pin 1 on the rear of your drive.

Normally, Pin 1 is the upper-right most pin on the rear of the

drive, and may be labeled "Pin 1", "A0", "ID 1", "1-Signal" etc.

(See Figure 3 for Sample Configuration)

4. Referencing the documentation that came with your

drive, be sure to Disable any automatic or passive drive

termination features on the drive itself.

NOTE: If you are unable to match the SCSI/Activity Jumper

connector to the drive, than your drive is NOT compatible with

this model of Compaq

Select and Attach Cover Grill to Tray

1. Select and attach the appropriate cover grill to your tray. This

selection will depend on the format of drive you are using as

well as your current Proliant

2. The cover grill attaches by inserting the four feet on the bottom of the cover through the Tray Cover Slots

(Figure 2) and then sliding the cover forward so that the front, beveled part of the cover is flush with the

beveled portion of the tray.

3. The cover can be further secured by mounting two screws through the side mounting holes on the sides of

the cover to the appropriate mounting holes in your drive, if available.

Insert Tray into Receiving Cage

1. Referencing Figure Four, apply pressure between your thumb and forefinger on the tray release levers on

the front of the tray. This should allow the levers to swing out, thus allowing you to slide the tray into the

receiver on your server.

2. Gently slide the tray into the receiver until you feel the PCB connector on the back of the tray touch the

connector.

3. Rotate the Release Levers back into the locked position. You should hear and feel a click when the levers

lock into place. This should force the tray completely into the receiver connector and snugly lock the tray into

the server.

DataStor, 12601 Monarch Street, Garden Grove, CA 92841-3918

Phone (800) 777-6621 / Fax: (714)833-9600 / Web Site: www.dstor.com

Installation Guide - Hot Plug Tray, HD 68pin, Compaq Proliant , Rev 1.0 - March 1999 - P/N CQPTUWS

Copyright 1999 by DataStor, Inc. All rights reserved. No part of this document may be reproduced in any form without prior written consent from DataStor. The information and specifications in this document are subject to change

without notice. Changes to this document are incorporated in new versions. DataStor, and the DataStor logo are reqistered trademarks of DataStor, Inc. Other trademarks used herein are the property of their respective owners.

Proliant

tray receiver configuration.

Compaq

and Proliant

are both Trade Marks of Compaq Computer Corporation.

This document was printed in the United States Of America.

SCSI/Activity Jumper

Figure 3

Tray SCSI

Activity

Pin 1 (Red Wire)

Connector

Drive Jumper Block

Figure 4

Tray Release Levers

Close-Up View

Figure 7

Configuration