DVS EC PREMIUM CONNECT Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DVS EC PREMIUM CONNECT. DVS EC PREMIUM CONNECT 6 pagina's.

Pagina afdrukken

Humidity Settings

For adjusting the sensitivity of the system to an

air supply which is more humid than the air inside

the home. A higher setting will mean the system

reacts more quickly to a humid air supply then

remains off for a period of time and until the air

supply is dry enough to continue ventilating your

home. The DVS® technician sets this function

when the system is installed, however, this

setting can be increased or decreased.

Note: To prevent nuisance stopping and starting

(oversensitivity) the DVS® is programmed to

allow some minor higher air supply humidity

readings before it will stop ventilating. Please call

DVS® on 0800 387 387 if you need assistance

and before you adjust these settings.

Humidity settings

Touch settings icon

then –

SETTINGS >

– Scroll the Humidity

HUMIDITY CONTROL

sensitivity or Humidity time up or down to the

level you wish -

OK > EXIT

WiFi connection and software upgrades

To check for upgrades or reconnect to your WiFi

Touch the WiFi icon

then choose – WiFi Scan or Check for upgrades (whichever is applicable) – then follow the instructions.

Clock

To manually adjust the clock

11:20

Touch the clock numbers

Filter change reminder reset

Touch settings icon

then –

SETTINGS > FILTER OPTIONS > NEW FILTER INSTALLED > YES > EXIT > EXIT

Note: This setting is intended to reset the filter reminder on your system. Resetting this means that you will receive a

reminder to change your filter again, on the control panel, in 12 months.

For further assistance please call DVS

For enabling or disabling the CO

technician enables this function and pairs the sensor(s) when the

system is installed, however, this function can be Enabled (turned

on) or Disabled (Turned off).

Enable / Disable

Touch settings icon

(touch the Enable/Disable slide switch icon to change to Enable or

Disable) -

The DVS® Connect range has one remote plug in CO

standard inclusion. Extra sensors can be fitted with a maximum

of four sensors per system. When multiple sensors are fitted the

system uses the average CO

a higher ventilation rate when the average CO

above 1000ppm.

Connecting to the system

Plug in the CO

on the plug so the sensor has power to it (leave the sensor plugged

in and turned on at all times) – Go to the control panel and touch

the settings icon

– Go back to the sensor, hold in (you will need to use a toothpick,

matchstick, sharpened pencil or similar) the recessed button on the

sensor for 5 seconds until the green light emitting from the bottom

of the sensor holds solid (this starts the pairing process) – Go back to

the control panel and when the pairing is complete -

If the system did not have a CO

will notice a new bar appears on the home screen. This is the CO

level indicator mentioned above in the "On your home screen"

section.

then -

SET DATE AND TIME > EXIT

Sensing & Control

control function. The DVS®

then –

SETTINGS > CO

OK > EXIT

Sensors - connecting to the system

reading across all sensors to activate

sensor in your room of choice and turn on the switch

then –

UTILITIES > MANAGE CO

sensor connected previously you

on 0800 387 387

CONTROL > ENABLE

sensor as a

concentration rises

> ADD SENSOR

EXIT > EXIT