2easy DT-RLC Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 2easy DT-RLC. 2easy DT-RLC 11 pagina's. Relay actuator

NC:The normally-closed contact to COM.

COM: The common contact of the unlock/light relay.

NO: The normally-open contact to COM.

Lock Control Jumper: To select the lock type:

POWER:Working indicator, it will light up when plugs in power supply.

IN-USE:Unlock/light indicator, it will light up when unlock(or turn on the light).

Bus:Connect to the bus line, no polarity.

DIP :Used for setting the address of the RLC.

3. Unit Mounting

DT-RLC

GND NO COM NC

POWER

IN-USE

DIN Rail Mounting

4. How To Set The Work Mode

Note that the factory default is lock control mode.

1).In DIP1 = ON, DIP2 = ON, DIP3 = OFF status, exit button(S1 and GND) short-

circuit, meanwhile, the DT-RLC will power-on to activate the setting mode;

2).In setting status, struck repeatedly DIP1 four times to switch work modes:

A.When the IN-USE indicator flashes once, it means the system will enter the lock

control mode.

B.When the IN-USE indicator flashes two times, it means the system will enter the

light control mode.

3).When the setting complete,it will automatically restart.

Please note the setting state valid within 5 seconds, more than five seconds without

operation, it will exit the setting mode automatically.

2-WIRE SYSTEM

12V S2

S1 GND

BUS BUS RISER

see section 5.3, 5.4.

-2-