Airwell RC 08B Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} Airwell RC 08B. Airwell RC 08B 7 pagina's.

USIING THE REMOTE CONTROL UNIIT

HOW TO INSTALL BATTERIES

Remove the lid in the rear part of the remote control unit.

Insert two AAA alkaline batteries of 1, 5 V- DC. Make sure to insert the batteries

according to the polarity(+/-) marked in the battery compartment.

Push the lid back on.

HOW TO REMOVE BATTERIES

Remove the lid in the rear part.

Press the battery toward the negative end and lift it out by its positive end as shown.

Remove the other battery in the same way.

General Note:

Replace the batteries when the remote control unit display fails to light, when the air

conditioner does not receive the remote control unit signals or when the low battery icon

is displayed.

Remove the batteries if you do not use the remote control unit for more than one

month.

The batteries last about six months, depending on how much you use the remote

control unit.

The batteries of the remote control contain polluted substances Exhausted batteries

must be disposed according to local laws.

TEMPERATURE SENSOR SELECTOR

Under normal conditions the room temperature is detected and checked by the

temperature sensor placed in the air conditioner.

Press the remote control I FEEL button to activate the temperature sensor placed in

the remote control. This function is designed to provide a personalised environment

by transmitting the temperature control command from the location next to you.

Therefore, in using this function, the remote control should always be aimed,

without obstruction, at the air conditioner.

OPERATION WITH THE REMOTE CONTROL UNIT

Check that the circuit breaker on the power panel is turned ON and the STANDBY lamp

is light up.

When using the remote control unit, always point the unit transmitter head directly at the

air conditioner receiver.

HOW TO TURN ON THE AIR CONDITIONER

Press the ON/OFF

button to turn the air conditioner on.

HOW TO SET THE PRESENT TIME

1. Hold down the TIMER button for at least 2 seconds to set present time.

The time indication alone flashes.

2. Press the + or - buttons until the present time is displayed.

3. Press the TIMER button to stop the indication flashing.

OPERATIION