Agriframes 4ft Green Rose Arch Montage-instructies - Pagina 2

Blader online of download pdf Montage-instructies voor {categorie_naam} Agriframes 4ft Green Rose Arch. Agriframes 4ft Green Rose Arch 3 pagina's.

Parts List

Assembly Instructions

1. Preparation

1.1. Take four of the 37½" uprights and tap an end plug into the standard end of each.

1.2. Place a screw in each T joint but only tighten the screws enough to hold them in.

Make sure the screw points do not protrude into the inside of the joints as they will

scratch the coating when they are attached to the tubes.

1.3. Take the eight 16¾" spacers. Push T joints onto both ends of all of them. Lay each

assembly flat to ensure the joints are parallel as shown below then measure the

exposed tube and ensure that it is 13 " long. If the measurement is greater than this

you will need to use a rubber mallet to knock the joints home.

2. Assembling the roof section

2.1. Refer to the diagram below. Take the four York curves and three of the 16¾" spacer bar assemblies

from above. Connect each reduced end curve to a standard curve to make two semicircular hoops.

Slide a spacer assembly onto the curves and attach it in the centre of the curves so that it covers the

join. Slide a spacer onto each side of the assembly. Do not attach these spacers; just temporarily slide

them onto the bottoms of the curves.

2.2. Measure the diagonals of the roof section to ensure it is square and adjust if necessary.

Quantity

37½" uprights (reduced one end)

York curves (plain ends)

York curves (reduced one end)

Quantity

Optional Component

Lattice panels 4 cells high x 3 cells wide

Components

16¾" spacer bars

Holemaker

T joints

Screws

" end plugs

" moisture seals

Lattice ties

13 "