DYNACO Stereo 120 Handmatig - Pagina 4
Blader online of download pdf Handmatig voor {categorie_naam} DYNACO Stereo 120. DYNACO Stereo 120 10 pagina's. Installing the really big heatsink for the power supply
Pagina afdrukken
Important Safety Notes
By purchasing this kit, you have agreed to hold AkitikA, LLC harmless for any injuries
you may receive in its assembly and/or use. To prevent injuries:
Wear safety glasses when soldering to prevent eye injuries.
Always unplug the power before working on the amplifier.
Large capacitors hold lots of energy for a long time. Before you put your hands
into the amplifier:
o Pull the AC plug!
o Wait 1 full minute for the capacitors to discharge!
Remove jewelry and rings from your hands and wrists, or anything that might
dangle into the amplifier.
If working in the amplifier, keep one hand in your pocket, especially if you're
near the power supply or power supply wires. This can prevent serious shocks.
Build with a buddy nearby. If you've ignored all the previous advice, they can
dial 911 or get you to the hospital.
About Components
We reserve the right to make design/or component changes at any time without prior
Recommended Solder
The kit must be assembled with 60/40 Rosin Core solder. The recommended diameter is
0.032 inches. Among many such sources of solder, I have used
Kester 24-6337-8800 50 Activated Rosin Core Wire Solder Roll, 245 No-Clean,
63/37 Alloy, 0.031" Diameter. This is a 1 pound roll of solder. No-clean means
that it leaves the minimum possible residue on the PCB.
MG Chemicals 60/40 Rosin Core Leaded Solder, 0.032" Diameter, 0.6 oz Pocket
Pack
Section 2: Removing the PSUG Power Supply and stock
Heatsink
Opening the Amplifier
1. Make sure the amplifier is unplugged. If it was recently powered allow the amp
to sit for one full minute before proceeding.
2. Remove the four screws along the outside edge of the bottom that hold the cover
in place (see Figure 1).
notification.
Page 4 of 10