GREAT PLANES FW-190 Focke Wulf Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES FW-190 Focke Wulf. GREAT PLANES FW-190 Focke Wulf 20 pagina's.

❏ ❏

6. Install a black nylon snap keeper onto the pushrod

at the control horn.

❏

7. Install the rudder and elevator pushrods in the same way

as the ailerons. Use the 5" [127 mm] prebent pushrod for the

rudder and the 2-3/4" [70 mm] prebent pushrod for the elevator.

Install the Motor & Speed Control

❏

1. Connect the output wires of your ESC to the motor.

Check that the motor operates in the proper direction prior

to installing it.

❏

2. Install the ESC as shown using a small section of hook

and loop tape. Place the hard "hook" side in the provided

cutout in the fuselage and the softer "loop" side on the back

of the ESC. If your ESC has a BEC switch, install it in the

provided cutout. For some electronic speed controls, it may

be necessary to trim the foam slightly to allow for wire

clearance and switch mounting.

❏

3. Slide the gearbox onto the square wood stick in the

nose. Secure it with the supplied #2 x 3/8" [9.5 mm] screw.

❏

4. Install the prop saver onto the gearbox output shaft.

The screws should seat down into the flat spots on the shaft.

Add a drop of thread-lock and be sure the screws are

tightened to prevent them from backing out during operation.

Note: The prop saver has two different diameters. Match the

size of your prop hub to the prop saver before installing the

prop to the gearbox. Attach the prop using the supplied

black O-ring.