GREAT PLANES Gee Bee Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES Gee Bee. GREAT PLANES Gee Bee 16 pagina's. Model aircraft great planes gee bee

Pagina afdrukken

Measure the high rate elevator throw ﬁ rst...

❏

11. Hold a ruler vertically on your workbench against the

widest part (front to back) of the trailing edge of the elevator.

Note the measurement on the ruler.

❏

12. Move the elevator up with your transmitter and move

the ruler forward so it will remain contacting the trailing edge.

The distance the elevator moves up from center is the "up"

elevator throw. Measure the down elevator throw the same way.

❏

13. Depending on your radio, you may have to adjust the

mechanical position of the pushrod linkage in order to achieve

the proper throw. This is preferred to adjusting AFR, ATV or

servo end points in the transmitter because it preserves the

control resolution of the servo and allows for better control

of the model.

These are the recommended control surface throws:

LOW RATE

Down

3/16"

[5mm] 6°

Right

1/2"

[13 mm] 10°

Down

1/2"

[13 mm] 14°

If your radio does not have dual rates, we recommend setting

the throws at the low rate settings.

NOTE: The throws are measured at the widest part of the

elevators, rudder and ailerons.

To ensure a successful ﬁ rst ﬂ ight, set up your Gee Bee

EP Rx-R according to the control throws speciﬁ ed in this

manual. The throws have been determined through actual

ﬂ ight testing and accurate record-keeping, allowing the

model to perform in the manner in which it was intended.

After you have become accustomed to the way the Gee Bee

EP Rx-R ﬂ ies, you can adjust the amount of control throw

to match your ﬂ ying style. However, too much control throw

could make the model too responsive and difﬁ cult to control,

so remember, "more is not always better."

HIGH RATE

3 /16"

3/8"

[10 mm] 12°

[10mm] 12°

Left

Right

1/2"

3/4"

[19mm] 15°

[19 mm] 15°

1/2"

3/4"

[19mm] 21°

[19 mm] 21°

Down

3/8"

Left

3/4"

Down

3/4"