GREAT PLANES Gee Bee Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Gee Bee. GREAT PLANES Gee Bee 16 сторінок. Model aircraft great planes gee bee
Друкувати сторінку
Measure the high rate elevator throw fi rst...
❏
11. Hold a ruler vertically on your workbench against the
widest part (front to back) of the trailing edge of the elevator.
Note the measurement on the ruler.
❏
12. Move the elevator up with your transmitter and move
the ruler forward so it will remain contacting the trailing edge.
The distance the elevator moves up from center is the "up"
elevator throw. Measure the down elevator throw the same way.
❏
13. Depending on your radio, you may have to adjust the
mechanical position of the pushrod linkage in order to achieve
the proper throw. This is preferred to adjusting AFR, ATV or
servo end points in the transmitter because it preserves the
control resolution of the servo and allows for better control
of the model.
These are the recommended control surface throws:
LOW RATE
Up
Down
3/16"
[5mm] 6°
[5mm] 6°
Right
1/2"
[13 mm] 10°
[13 mm] 10°
Up
Down
1/2"
[13 mm] 14°
[13 mm] 14°
If your radio does not have dual rates, we recommend setting
the throws at the low rate settings.
NOTE: The throws are measured at the widest part of the
elevators, rudder and ailerons.
To ensure a successful fi rst fl ight, set up your Gee Bee
EP Rx-R according to the control throws specifi ed in this
manual. The throws have been determined through actual
fl ight testing and accurate record-keeping, allowing the
model to perform in the manner in which it was intended.
After you have become accustomed to the way the Gee Bee
EP Rx-R fl ies, you can adjust the amount of control throw
to match your fl ying style. However, too much control throw
could make the model too responsive and diffi cult to control,
so remember, "more is not always better."
8
HIGH RATE
Up
3 /16"
3/8"
[10 mm] 12°
[10mm] 12°
Left
Right
1/2"
3/4"
[19mm] 15°
[19 mm] 15°
Up
1/2"
3/4"
[19mm] 21°
[19 mm] 21°
Down
3/8"
Left
3/4"
Down
3/4"