Automate AM2 Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Automate AM2. Automate AM2 18 pagina's.
Ook voor Automate AM2: Gebruikershandleiding (19 pagina's)

Pagina afdrukken

H1/11 BLACK (-) Chassis Ground Connection

Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt

that DOES NOT have any vehicle component grounds attached to it. A screw should only be used

when in conjunction with a two-sided lock washer. Under dash brackets and door sheet metal are

not acceptable ground points. It is recommended that all security components be grounded at the

same location.

H1/12 BROWN (-) Horn Honk Output

This wire supplies a (-) 200 mA output that can be used to honk the vehicle horn. It outputs a single

pulse when locking the doors with the remote, and two pulses when unlocking with the remote. This

wire will also output pulses for 30 seconds when the Panic Mode is activated. If the vehicle has a (+)

horn circuit, an optional relay can be used to interface with the system, as shown below.

H1/13 LT. GREEN/BLACK Factory Alarm Disarm

This wire sends a negative (-) 200ma pulse every time the system is unlocked/disarmed or an

optional channel is activated. This can be used to pulse the disarm wire of the vehicle's factory anti-

theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown in the diagrams below.

n n o o t t e e : : In most instances the negative pulse output can be connected directly to the

factory disarm wire. The circuit shown on the left below is provided for those

instances where direct connection will not correctly function.

2007

Directed Electronics