Automated Logic UNI/59 Technische instructies - Pagina 8

Blader online of download pdf Technische instructies voor {categorie_naam} Automated Logic UNI/59. Automated Logic UNI/59 10 pagina's.

Pagina afdrukken

{1: Logistat}

{1: PWM request chan=11, exp=0}

{1: AirFlow primary}

{1: Floating motor}

{2: Logistat}

{2: PWM request chan=11, exp=0}

{2: AirFlow primary}

{2: Floating motor}

{3: Logistat}

{3: PWM request chan=11, exp=0}

{3: AirFlow primary}

{3: Floating motor}

{4: Get Raw AI request chan=31}

{4: Get DI request chan=22}

{4: Logistat}

{4: Set Raw AO request chan=41, exp=0}

{4: PWM request chan=11, exp=0}

{4: AirFlow primary}

{5: Logistat}

{5: PWM request chan=11, exp=0}

{5: AirFlow primary}

{5: Floating motor}

{6: Logistat}

{6: PWM request chan=11, exp=0}

{6: AirFlow primary}

{6: Floating motor}

lines). Some panels can be reinitialized

by resetting the panel.

• Make sure the module driver and all

GFBs are transferred into the module.

You can verify this by checking the

module status report for the UNI/59

module.

• Make sure the module driver

parameters and the parameters for each

GFB are set up properly in SuperVision.

Communicating with the Workstation

You can connect a workstation or portable

computer directly to the UNI/59 module using

an APT and the module's Access port (see

Figure 10). This type of connection can be

used to troubleshoot the module or transfer

memory.

The baud rate of the Access port is

determined by the first switch on the eight-

position DIP switch (see Figure 7 on page 6). If

Revised 1/3/01 • UNI/59

0& $ 1 23

1 1 23

$ 0& $ 1 23

0 0& $ 1 23

, # +3 $ 1 24

, # -- $ 1 24

# 5 # 43 1 24

Figure 9. Sample Diagnostic Capture

you need to change the switch's position, turn

the UNI/59 module off first. Once you have

adjusted the switch, turn the module back on.

1. Connect the computer's serial port to the

Exec. 4 relay

A P T

Isolate Network

ACCESS

PORT

6 1

Mode Select

2- Tx out

3- Rx i n

+5V

5- Gnd

TTL

485

1,6,8- +10V or floating

Figure 10. Using the Access Port

EIA-232 port of the APT using a standard

straight-through serial cable.