Automatic Technology AM-808 Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} Automatic Technology AM-808. Automatic Technology AM-808 4 pagina's.

AM-888 Installation Instructions

Affix with screw here

AM-888 Door Openers

ITEM

DESCRIPTION

NETWORK TRANSCEIVER NTR-1V1 AY

TIMING HARNESS 400MM VR12 AY

TAPTITE SCREW "P" M4 X 12

Preparation of Opener

a. Disconnect the power supply to the opener.

b. Open the side cover on the right hand side (looking from back of unit).

c. Connect the harness

board.

d. Place the transceiver

provided and affix with one (1) Taptite Screw

e. Refit the cover.

Re-setup and Test the Opener

a. Reconnect power and remove the button cover.

b. Setting Limits:

i. If limits have not been set, follow the openers installation sheet to set limits.

ii. If limits were set previously, clear limits and follow openers installation sheet

to set limits.

c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.

To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be

installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with

any other antenna or transmitter.

Aerial slot

QTY

to the network / programmer pin on the control

inside the cover, threading the aerial through the slot