Automatic Technology AM-808 Instruções de instalação - Página 3
Procurar online ou descarregar pdf Instruções de instalação para Abertura de porta de garagem Automatic Technology AM-808. Automatic Technology AM-808 4 páginas.
Imprimir página
AM-888 Installation Instructions
Affix with screw here
AM-888 Door Openers
ITEM
DESCRIPTION
1
NETWORK TRANSCEIVER NTR-1V1 AY
2
TIMING HARNESS 400MM VR12 AY
3
TAPTITE SCREW "P" M4 X 12
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Open the side cover on the right hand side (looking from back of unit).
c. Connect the harness
board.
d. Place the transceiver
1
provided and affix with one (1) Taptite Screw
e. Refit the cover.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers installation sheet to set limits.
ii. If limits were set previously, clear limits and follow openers installation sheet
to set limits.
c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
1
3
2
Aerial slot
QTY
1
1
2
to the network / programmer pin on the control
2
inside the cover, threading the aerial through the slot
.
3