DynaGen GSC400 Series Handleiding voor kalibratiehulpprogramma - Pagina 13
Blader online of download pdf Handleiding voor kalibratiehulpprogramma voor {categorie_naam} DynaGen GSC400 Series. DynaGen GSC400 Series 18 pagina's. For generator
Ook voor DynaGen GSC400 Series: Handleiding voor programmeurs (4 pagina's)
Pagina afdrukken
3. If the GSC400 is not already in the
RUN mode place the GSC400 in
the RUN mode and wait until AC
voltage reading stabilized.
Click OK.
The utility will then read the
generator voltage.
4. Finally click Next.
5. Out of the two AC currents
(loads) you picked for
calibration place the smaller
load on the generator and
measure the actual current.
Record the current in the utility.
Click Next.
13 of 18
Figure 9
Figure 10
Figure 11