Automation Networks Highway Plus ANC-100e Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Automation Networks Highway Plus ANC-100e. Automation Networks Highway Plus ANC-100e 19 pagina's. Ethernet to data adapter

Pagina afdrukken

1. Configuration and Interface

ANC-100e

Ethernet to DH+ Adapter

Using ANC-100e

Power and protection

Device requires 9...24 V DC power supply and consumes, depends of the voltage from 94mA at 9V to

35mA at 24V. Device has a diode protection against wrong power wiring polarity.

All device inputs (power, DH+, Ethernet) are TVS protected from spikes and transients.

Connections

To connect ANC-100e device to your existing DH+ network or directly to another DH+ device, please

use one of the connectors included with the product.

1. Connect the DH+ cable to the ANC-100e left most and right most terminals of the Phoenix

3 pin connector leaving the middle pin not connected. The polarity of blue and clear cables

does not matter

2. Connect ANC-100e to the Ethernet network or a free Ethernet port on the computer or a

free Ethernet port on a network hub/switch

3. The "Ethernet" LED light should blink intermittently for a moment

4. The "DH+" light will blink every 3 seconds indicating that the device is connected and

associated to a DH+ network

Due to ANC-100e unique DH+ Polarity Detection feature, the way the individual conductors (1/2) are

connected does not matter, since upon startup, ANC-100e will AutoDetect and configure itself to use the

correct polarity for communication regardless of the DH+ cable polarity.

LED Diagnostics

ANC-100e is equipped with three LEDs used for visual status and diagnostic display.

LED labeled "Ethernet" indicates the data exchange between the ANC-100e and the user PC or any

device on the Ethernet network. When the device sends/receives a packet to/from the PC/Ethernet

Network, this LED blinks indicating packet exchange.

LED labeled "Diag" indicated the current status of the ANC-100e device on the DH+ network:

•

"LED Solid Red" indicates that the device is not currently associated on a DH+ network.

•

"LED Solid Green" indicates that the device is associated on the DH+ network

Connect the power supply + and – wires to the appropriate

connection points on the power connector supplied with

the device. Please reference the figure on the left for proper

wiring.

System grounding in most cases is not necessary but may be

useful for protection against high power spikes.

User Manual 6