Celestron StarSeeker 80mm Gebruiksaanwijzing - Pagina 5
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Celestron StarSeeker 80mm. Celestron StarSeeker 80mm 15 pagina's. F80 eq wa 80mm (3.1”) refractor telescope
Ook voor Celestron StarSeeker 80mm: Gebruiksaanwijzing (17 pagina's)
Pagina afdrukken
5.
Tighten all bolts and wing nuts to ensure proper stability.
B. Before proceeding further, locate knobs #19 and #16 and tighten them finger tight after orienting the
mount as illustrated in figure 1.
1.
Locate the declination cable holder (where #21 fits on). Locate the declination cable (the shorter of the
two cables) and attach the cable (#21) to the cable holder by tightening the thumb screw on the cable
end. The thumb screw should be tightened down hard on the flat surface of the cable holder after
backing off the cable about 1/4" from being fully engaged. This method helps ensure there is no
slippage when using the cable.
2.
You may reverse the position orientation of the Declination cable to suit your preference if desired.
3.
Locate the right ascension cable holder (where #18 fits on). Locate the right ascension cable (#18) and
attach it the same way as the declination cable was attached in the last section.
4.
Slide the counterweight shaft (#9) through the counterweight (#8). Use the counterweight lock (#10) to
lock the counterweight in place. By holding the counterweight in one hand, thread the counterweight
shaft clockwise into the equatorial mount as shown in figure 1.
C. You are now ready to put the telescope optical tube (#2) onto the equatorial mount (#6).
The optical tube is held to the mount with two mounting rings. On the bottom of the mounting rings are square
extrusions — one on each ring. This portion of the ring slides over the ends of the mounting platform to hold
the telescope in place (see figure 2).
1.
Loosen the knurled screws on the side of the mounting rings and remove the tube ring closest to the focuser
end of the optical tube.
2.
Slide the remaining tube ring towards the objective end of the telescope tube.
3.
Place the telescope tube on the mounting platform and orient it so that the objective lens is opposite the
slow motion control handles.
4.
Slide the attached tube ring down until the square extrusion fits over the end of the mounting platform.
5.
Insert one of the mount platform screws through the bottom of the square extrusion and thread it into the
mount.
6.
Open the second tube ring and place the square extrusion under the other end of the mounting platform.
7.
Close the tube and slightly tighten the knurled screw to hold the tube ring in place.
8.
Thread the second mounting screw through the square extrusion of the tube ring and into the mounting
platform. Tighten both mounting screws.
9.
Tighten the knurled screws that clamp the mounting rings in place . This will keep the telescope from
sliding back and forth in the mounting rings.
D. Put the diagonal (#23) into the focuser (#22) and tighten the thumb screw on the focuser to hold it in
place.
E. Put the eyepiece (#1) into the diagonal and tighten the thumb screw to hold it in place.
7