Autonics PA10-V Snelstarthandleiding - Pagina 5
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Autonics PA10-V. Autonics PA10-V 8 pagina's. Multifunctional sensor controller
Ook voor Autonics PA10-V: Gebruiksaanwijzing (2 pagina's)
Pagina afdrukken
PA10 Series
Operation Mode (PA10-U)
● MODE 6 Low-speed detection mode
OUT will be ON when input signal (IN1) is longer than setting time by comparing it to the setting time by one cycle.
Note)Above is when input logic is OR and it will be the same by using IN2 input signal terminal instead of IN1.
Note)When use MODE 6 as above, be sure that OUT will be work at the same time with power supply.
● MODE 7 High-speed detection mode
OUT will be ON when input signal (IN1) is shorter than setting time by comparing it to the setting time by one cycle.
Note)Above is when input logic is OR and it will be the same by using IN2 input signal terminal instead of IN1.
Time switches
Set the time by time switches (T1, T2) and front time adjuster (ADJ).
MODE
Item
TIME S/W
※ Range of operating rpm is 1 pulse per 1 revolution.
※ When the pulse is increasing per 1 revolution, range of operating rpm is decreasing.
● MODE 8 Flip-Flop mode [ OUT latch operation ]
When IN1 signal is input then the Flip-Flop output will be ON (SET). When the IN2 signal is input, Flip-Flop Signal will be
OFF (RESET).
Note)IN2 will be prior to all input signal.
Note)Both
Note)There is no Timer function in Flip-Flop Mode, therefore use this unit with time switches (T1, T2) are OFF.
O-6
IN1
ON
(IN2)
OFF
Progressing time
TIME
setting time
ON
OUT
OFF
IN1
ON
(IN2)
OFF
Progressing time
TIME
setting time
ON
OUT
OFF
MODE 1 to MODE 7, MODE 12
Setting time range
0.01 to 0.1sec
0.1 to1sec
1 to 10sec
10 to 100sec
ON
IN1
OFF
ON
IN2
OFF
ON
OUT
OFF
and
switches are allowed to use.
MODE 6 to MODE 7
Input frequency
rpm
100 to 10Hz
6,000 to 600rpm
10 to 1Hz
600 to 60rpm
1 to 0.1Hz
60 to 6rpm
0.1 to 0.01Hz
6 to 0.6rpm