activTek INDUCT 5000 Handmatig - Pagina 14

Blader online of download pdf Handmatig voor {categorie_naam} activTek INDUCT 5000. activTek INDUCT 5000 16 pagina's. Electronic air purification system
Ook voor activTek INDUCT 5000: Handmatig (16 pagina's)

Pagina afdrukken

REPLACING ThE BALLAST

Replacement of the Ballast may be necessary if after replacing the ActivePure Cell(s) the

lamp still does not become active.

CAUTION: NEVER ATTEMPT TO CHECK OPERATION OF THE

ACTIVEPuRE CELL(S) BY DIRECT OBSERVATION. SEVERE EYE DAMAGE

CAN RESuLT. uSE THE INDICATOR LAMPS ON THE BOTTOM OF THE

Note: Disconnect power at the breaker or fuse panel before servicing unit.

1. Disconnect power at the breaker or

fuse panel before servicing unit.

3. Remove the two (2) nuts on the

top and bottom side of the ballast

to pull ballast from assembly.

2. Open the ballast housing by

removing the four (4) screws

then removing cover.

4. Remove the wires (activTek

INDUCT 10000 - 8 wires, INDUCT

5000 - 6 wires) from ballast by

pressing a small screwdriver into

the wire release.

wire release