Autopage Car-Pro CPX-RS2 Installatiehandleiding - Pagina 15
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Autopage Car-Pro CPX-RS2. Autopage Car-Pro CPX-RS2 17 pagina's. Remote engine starter
Pagina afdrukkenH. Connect terminal 85 of the relay to the Drivers Door side of the pin switch wire previously cut in step B.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is
the case, it must be installed as shown in the diagram above. The anode (Non Stripped) side must be connected to the
WHITE/ BLACK wire (H3/4) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin
switch.
METHOD 2
Connected to (-) Negative
Safety Input Wire
White/ Black (H3/4)
To connect to the key in sensor circuit as shown for method 2:
A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down wire WHITE/
BLACK (H3/4), using a 4003 series diode as shown above.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is
the case, it must be installed as shown in the diagram above. The anode (Non Striped) side must be connected to the
WHITE/ BLACK wire (H6/4) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin
switch.
AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS INDICATED IN ANY OF THE PREVIOUS
ALTERNATE CONFIGURATIONS, THIS CIRCUIT MUST BE TESTED FOR OPERATION.
Retest by following the steps outlined in the NEUTRAL START SAFETY TEST shown in this manual.
RS2
To Hood Pin Switch
Safety Shut Down (H3/4)
1N4003
Ignition Key In Sensor
Switch Closes with Key
In Ignition Cylinder
Switch
15
August, 2005