Autopage Car-Pro CPX-RS2 Руководство по установке - Страница 15

Просмотреть онлайн или скачать pdf Руководство по установке для Дистанционное пусковое устройство Autopage Car-Pro CPX-RS2. Autopage Car-Pro CPX-RS2 17 страниц. Remote engine starter

Печатать страницу

H. Connect terminal 85 of the relay to the Drivers Door side of the pin switch wire previously cut in step B.

Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is

the case, it must be installed as shown in the diagram above. The anode (Non Stripped) side must be connected to the

WHITE/ BLACK wire (H3/4) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin

switch.

METHOD 2

Connected to (-) Negative

Safety Input Wire

White/ Black (H3/4)

To connect to the key in sensor circuit as shown for method 2:

A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.

B. Cut this wire and connect the ignition cylinder side to chassis ground.

C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder.

D. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down wire WHITE/

BLACK (H3/4), using a 4003 series diode as shown above.

Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is

the case, it must be installed as shown in the diagram above. The anode (Non Striped) side must be connected to the

WHITE/ BLACK wire (H6/4) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin

switch.

AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS INDICATED IN ANY OF THE PREVIOUS

ALTERNATE CONFIGURATIONS, THIS CIRCUIT MUST BE TESTED FOR OPERATION.

Retest by following the steps outlined in the NEUTRAL START SAFETY TEST shown in this manual.

RS2

To Hood Pin Switch

Safety Shut Down (H3/4)

1N4003

Ignition Key In Sensor

Switch Closes with Key

In Ignition Cylinder

Switch

August, 2005