Autopage RS-777 Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Autopage RS-777. Autopage RS-777 14 pagina's. Remote engine starter with alarm system

Pagina afdrukken

U. POWER SAVER MODE (Default OFF)

By table - 2 -1– 4 under Menu mode while "POWER SAVE" icon flash press

Save

" unit under power save mode, the LCD remote transceiver use "0" current to save the battery power, LCD

indicate "SAVE ".

Exit: Press any button of the LCD remote transmitter to exit "Power Save Mode".

V. POWER ON MEMONRY:

This security system is equipped with circuitry that will allow the unit to remember its alarm state if the

power is lost and then reconnected.

W. SECOND VEHICLE SECURITY OPERATION:

Your 1-way remote transmitter can be utilized to control a second vehicle security system, To program the remote

control transmitter to a second vehicle, follow the instructions

* For 1-way transmitter press button

1. Once shift button (

built-in.

2. Press any button on the remote control transmitter to control a second vehicle security system LED on Transmitter

will flash 2 times indicate it's 2

** For LCD transceiver – 2

a. By table-2-1-6 Press and hold

flash on the text field of LCD screen, press

c. Press & release

d. Select CAR 1 or CAR 2 by pressing

X. CHECK VEHICLE'S VOLTAGE:

Press and hold

button of LCD remote until

the LCD remote will show "VOLTS CHECK" icon flash on text area (see Table 2), then press

activate system Voltage check. Please note that this data is for your reference only. Please check the

exact data on vehicle.

A. TO REMOTE START THE VEHICLE:

When you want to start your vehicle,

1. Press

button once on the transmitter.

2. The parking light will activate to indicate the remote start received the signal.

3. The engine will start in approximately 5 seconds.

4. Once the engine is running, after couple seconds the parking lights will turn on and the climate controls

will activate and adjust the vehicle's interior temperature to your presetting. (While the vehicle is running,

the "minutes" digit on the LCD screen will flash and the will indicate count down timer based on the 5, 10,

20 or 30 minute run time set up by your installation center.)

5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down. (When the unit

shuts off the count down timer will turn off and the transmitter will play a melody.)

NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:

1. The hood is opened.

2. The brake pedal is pressed.

3. The optional remote start enable toggle is switched to the "OFF" position. (If installed)

4. The gear selector is in any gear other then "PARK" or "NEUTRAL"

SAFE START (Child safety mode)

Factory default is set to press the

to eliminate an accidental remote start:

1. The user presses the transmitter

2. The user presses the transmitter

NOTE: Contact your installing dealer to activate this feature.

B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE START:

To operate the vehicle while engine running from the remote start,

1. Insert the ignition key and turn it to "ON" (not the start) position.

2. Press the brake pedal.

Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.

C. TEMPORARY STOP FEATURE:

This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is

useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the

motor running and the climate control on.

RS-777 OP REV 1D

for 2 seconds until transmitter LED

)

is pressed the LED flash 2 times to indicate the second transmitter pin code has

car operation no matter which button is pressed.

car operation :

button until 2 beeps heard, release

button to move down the menu to #6, CAR SELECT

REMOTE START OPERATION:

button once on the transmitter to start the vehicle. You can program this feature

buttons twice within 3 seconds to start the vehicle. or

and

button at the same time to start the vehicle.

button to enter the menu mode.

button (text field show CAR 1 or CAR 2).

beeps sound , release and re-press

button, LCD HHU show

(flash 2 times )

s a shift button.

button

button for three times,

2013/05/29

button to