Autopage RS-777 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Autopage RS-777. Autopage RS-777 14 pagina's. Remote engine starter with alarm system

Pagina afdrukken

Note : You must override the alarm within 60 seconds. If not, the system will automatically re-arm.

EXAMPLE: To Override The System With The Password Code 83,

1. Enter the vehicle and turn the ignition switch to the 'ON' position.

(Alarm will sound.)

2. Within 5 seconds, Press and Release the Valet Switch 8 times, (When finished the system's siren will stop alarming,

lights stop flashing, but the vehicle can not be started or driven away.)

3. Within 15 seconds of entering the last digit code enter (the 1

4. Within 15 seconds, Press and Release the Valet Switch 3 times.

Turn the Ignition Switch to the "Off" position. 4 Chirps form siren/horn and 3 flashes from the parking lights will

indicate the system has disarmed.

I. VALET MODE:

VALET MODE:

(System in Disarm)

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your transmitter to

parking attendants or garage mechanics. When the system is in valet mode, all alarm functions and remote start

functions are bypassed, however, the remote panic feature and remote door locks will remain operational. To use the

valet mode, the system must first be disarmed either by using your remote transmitter, or by operating the Manual

Override sequence.

Get into/out valet mode using the ignition key.

Enter Valet Mode:

a). Under disarm mode, turn the ignition to "ON" position.

b). Press and hold valet switch for 2 seconds until the LED turns on. The LED will remain on as long as

the system is in 'valet mode'.

Exit Valet Mode:

a). Turn ignition 'on'.

b). Push and hold valet switch for 2 seconds, The LED will turn off indicate the system are exiting the

valet mode.

J. CAR LOCATOR

Under armed mode, press the

parking light will flash 12 times, for you to easily locate your car.

K. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency.

1. Press and hold the

2. During panic mode, the normal function of this transmitter button will be disabled. The transmitter

buttons can be used to lock and unlock the door (if the option is installed), however once the

pressed, the vehicle's starter disable device, (where installed) will be disengaged allowing the vehicle to start.

3. To stop the alarm, press and hold the transmitter

any transmitter buttons other than

immediately.

4. If the button is not pressed, the alarm will automatically stop after 30 seconds.

L. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

Light impact will trigger the warn-away signal.

Heavy impacts / Doors open /(if installed) Hood open / (if installed) Trunk open / Turning on the ignition key

will trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle's starter from cranking. The siren, horn, parking

lights, and dome light will turn on alerting of an intrusion for 30 seconds. Then it will stop and automatic

reset and re-arm. If the any one of the sensors or detectors is still active, the alarm system will sound a

maximum of 3 times of 30 seconds cycles

NOISE ABATEMENT CIRCUIT:

trigger sequences due to faulty door pin switches or environmental conditions such as thunder,

jackhammers airport noise, etc.

Here's how "Noise Abatement Circuit" works: The alarm triggers five times. Each time, the same sensor or

switch has triggered the alarm; the "Noise Abatement Circuit" will interpret this pattern of triggers as a false

alarm. After the third trigger, the "Noise Abatement Circuit" ignores, or bypasses, that sensor or switch until

a different sensor or switch is trigger.

"Noise Abatement Circuit" covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door

for 3 full cycles, the doors will be bypassed until the trigger ceases.

M. ANTI HI - JACKING

Warning: If you don't need the car jacking function in this alarm system, be sure to set car jacking feature

"OFF". This system is default setting all cars jacking "OFF".

ACTIVE ANTI CAR JACKING:

RS-777 OP REV 1D

button to active car locator function. The siren will chirp 6 times. The

button for 3 second. The alarm will immediately sound.

button is pressed and released, the panic mode will be turned off

Your system has a "Noise Abatement Circuit". It prevents annoying repetitive

code), turn the Ignition Switch "Off" and then "ON".

button on the transmitter again for 3 seconds. Also, if

2013/05/29

and

button is