Galebreaker Bayscreen Handleiding voor installatie en gebruik - Pagina 10

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Galebreaker Bayscreen. Galebreaker Bayscreen 16 pagina's.

Bayscreen

under no circumstances use levers to add more tension. Should the hooks slide

on the pillars then a preventative 'stop' should be fastened to the building upright.

ATTENTION: Tension ratchets fully, lack of tension will cause

damage to the Bayscreen. Only tension by hand, use of levers

could cause damage to the ratchets.

ATTENTION: To ensure the ratchet functions correctly there must

be a minimum of 150mm webbing (for 50mm ratchet) or 100mm

webbing (25mm ratchet) around the ratchet barrel for secure &

permanent tensioning of the screen.

ATTENTION: Overloading the ratchet barrel with webbing will

restrict the tension you can apply to the screen due to an

increase in friction and a decrease in leverage. To free surplus

webbing pull ratchet release catch on handle and open 180

degrees until ratchet body is flat and pull on webbing strap.

Mounting Screens in Series

When screens are installed in series they share a common pillar, the ratchet of

one screen can be set above or below the hook of the other screen creating an

offset. Alternatively they can be installed 'in line' as detailed in Figure 8(i)

(25mm webbing) and in Figure 8(ii) (50mm webbing).

10.

Install screens working from right to left as viewed from the side with the

webbing. When fitting the second screen, offer up the ratchet hook (D1 or D2)

to straddle the webbing of the previous screen and cut two slits in the fabric 4cm

long to coincide with the legs of the hook. Cut the material 1cm back past the

edge of the upright so that the hook contacts on the upright and does not put

load onto the fabric. Pass the ratchet hook through the slits and onto the

upright, then tension the screen as previously instructed.

-10-

Installation

ENG