HighPoint SSD7505 Handmatig gebruiken - Pagina 15

Blader online of download pdf Handmatig gebruiken voor {categorie_naam} HighPoint SSD7505. HighPoint SSD7505 19 pagina's. Using nvme raid aics with the dell precision 3930 rack workstation
Ook voor HighPoint SSD7505: Installatiehandleiding (14 pagina's), Installatiehandleiding (12 pagina's), Installatiehandleiding (15 pagina's), Snelle installatiehandleiding (6 pagina's), Snelle installatiehandleiding (8 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (19 pagina's)

Using HighPoint NVMe RAID AICs with the Dell Precision 3930 Rack Workstation

4. Uninstalling a HighPoint NVMe RAID AIC from the Dell

Precision 3930 Rack Workstation

a. Screwdriver (system cover require a screwdriver to open)

b. Wired ESD wrist strap (to prevent electrostatic accidents)

a. Use a wired ESD wrist strap that is properly grounded.

b. Shut down the system.

c. Insert a screwdriver and turn counterclockwise to unlock the system cover

latch.

d. Lift the latch upward to remove the system cover.

e. Remove the riser1 module from the system.

f. If you are using the SSD7140A, SSD7540, RocketAIC 7140AW, or RocketAIC

7540HW, you will need to disconnect the power cable to the 8-pin power

connector on the system and to the 6-pin power connector on the HighPoint

NVMe RAID AICs.

Note:

If you are not using SSD7140A, SSD7540, RocketAIC 7140AW, or

RocketAIC 7540HW, you can safely move to the next step.

g. Pull the riser1 module latch and push the release tab on the PCIe slot.

h. Holding the edge of the HighPoint NVMe RAID AIC, lift up to remove the