Galvin Engineering Flowmatic TZ-FLOWSENC24B Installatie van het product - Pagina 8
Blader online of download pdf Installatie van het product voor {categorie_naam} Galvin Engineering Flowmatic TZ-FLOWSENC24B. Galvin Engineering Flowmatic TZ-FLOWSENC24B 10 pagina's. Stainless steel retro fit bluetooth face plate 24v ac, suits enw. sensor
Pagina afdrukken
Product Installation Guidelines
5. Type of controller (left drop-down menu)
For the TZ-FLOWSENC24B controller the 'Wave' or
-
'Proximity' selection may be used depending on the
application. Please do not change the selection to
the , 'Urinal', 'Pan' 'PB2' or 'Flusher'.
7. Choosing the suitable mode
- 'Wave' mode:
•
If a hand is detected, the water will start and keep flowing until the time set in the 'Run time' section will
pass or another 'wave' will appear in front of the sensor.
- 'Proximity' mode:
•
If a hand is detected, the water turns on for as long as the hand is there, up to a certain timeout value set
in the 'Run time' section.
8. Settings 'Hygiene flush'.
-
Set the required time for Hygiene flush and press
'Upload'.
© Galvin Engineering Pty Ltd
Version 1, 8 September 2021, Page 8 of 10
Version 2, 8 September 2021, Page 8 of 10
6. 'Wave', 'Proximity' setting screens
contains the same setting parameters.
Run time (s) slider – to set the required
-
flow time.
'Detection threshold' slider – to set
-
sensing range. By setting smaller value
the detection distance is farther. Bigger
value is making the detection distance
shorter.
9. Connection menu.
-
By pressing the back arrow, the
connection screen will pop up.
The buttons allow to rename the controller,
set new PIN, disconnect, or go to setting
screen 'Next'.