AGS Parksafe Control Panel Installatie- en bedieningshandleiding - Pagina 7

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AGS Parksafe Control Panel. AGS Parksafe Control Panel 16 pagina's. Ventilation control panel
Ook voor AGS Parksafe Control Panel: Installatie- en bedieningshandleiding (16 pagina's), Installatie, bediening en onderhoud (16 pagina's), Installatie-, bedienings- en onderhoudshandleiding (20 pagina's)

Installation & Operation Manual

Wiring your Detector

Power and Modbus data are wired between detectors with the first

connected to a control panel DETECTOR CHAIN terminal.

One example of such cable is BELDEN 3082A.

If you are encountering noise or irregular problems with a Modbus link, the problem is likely related

to grounding, incorrect shielding or wiring mains power next to Modbus wiring.

To ground the data cable, the shield should be connected to [-] of the chain terminals.

Reversing the [D+] and [D-] connections of any device can lead to the whole system to stop

working owing to reverse polarity found on the terminals.

Not appropriately grounding the device can give false readings, fail completely or turn into a

safety hazard!

When wiring multiple detectors in a chain it is important to identify each and

every detector installed for the control panel to receive and display accurate

data corresponding with the correct detector type.

The ID configuration diagram is printed onto detector boards for

quick reference. All detectors are factory set to ID1.

ID Switches must be configured for each and every detector connected to a

system to receive and display accurate data!

We recommend a plan, map and/or marking the detector enclosures detailing ID and location!

AGS Parksafe Panel - IOM Iss: 6 10-20

For MODBUS communications, a shielded cable is used.

The shielding can be of 2 types: braided [mesh of thin

conducting wires] or foil (consisting of a thin sheet of metal

covering the twisted wires).

Parksafe