Dynojet Power commander FC Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} Dynojet Power commander FC. Dynojet Power commander FC 4 pagina's. 2018 kawasaki klx250s fuel controller
Ook voor Dynojet Power commander FC: Handleiding voor installatie-instructies (6 pagina's)

Pagina afdrukken

FIG.A

FIG.B

Unplug

FIG.C

IFC17900.01

www.powercommander.com

Remove the seat, all side panels, and the fuel tank.

Secure the PCFC module to the side of the battery with the supplied Velcro

(Fig. A).

Clean surfaces with the alcohol swab before attaching the Velcro.

Secure the PCFC ground wire with the small ring terminal to the negative (-)

terminal of the bike's battery.

Route the pair of 4-pin connectors towards the top of the rear fender.

Route the other wiring harness branch with the pair of 2-pin connectors

towards the throttle body.

At the top of the rear fender, locate and unplug the stock O2 sensor

connectors (Fig. B).

Plug the pair of 4-pin PCFC connectors in-line with the stock O2 sensor

connectors (Fig. C).

2018 Kawasaki KLX250S - 3