Dynojet Power commander FC 설치 지침 - 페이지 3
{카테고리_이름} Dynojet Power commander FC에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet Power commander FC 4 페이지. 2018 kawasaki klx250s fuel controller
Dynojet Power commander FC에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지)
FIG.A
FIG.B
Unplug
FIG.C
IFC17900.01
www.powercommander.com
1
Remove the seat, all side panels, and the fuel tank.
2
Secure the PCFC module to the side of the battery with the supplied Velcro
(Fig. A).
Clean surfaces with the alcohol swab before attaching the Velcro.
3
Secure the PCFC ground wire with the small ring terminal to the negative (-)
terminal of the bike's battery.
Route the pair of 4-pin connectors towards the top of the rear fender.
Route the other wiring harness branch with the pair of 2-pin connectors
towards the throttle body.
4
At the top of the rear fender, locate and unplug the stock O2 sensor
connectors (Fig. B).
5
Plug the pair of 4-pin PCFC connectors in-line with the stock O2 sensor
connectors (Fig. C).
2018 Kawasaki KLX250S - 3